MIMAKI SWJ-320 S4 - Page 182

© 2013 MIMAKI ENGINEERING CO.,LTD. 7.1.1 P.1
R.1.0
1
2
3
4
5
6
7
8
MAINTENANCE MANUAL > Troubleshooting > Details on Errors and Malfunctions > Concerning Errors and Malfunc-
Model
SWJ-320S Issued 2012.07.19 Revised F/W ver
Remark
1.0
Rev.
7.1.1 Concerning Errors and Malfunctions
 Outline
This chapter describes the troubleshooting for SWJ-320S.
 Rough Identification of the Source of the Trouble
At the beginning of troubleshooting, it is necessary to identify roughly which functions the trouble relates to.
Problems can be roughly classified into those that relate to the printer itself and those that involve the connection
between the printer and the host computer.
 Problems with the printer itself
The cause of the trouble can be identified by executing appropriate functions or using test functions.
 Problems concerning the connection to the host computer
Hardware: Broken wire or faulty contact of cables
Software: Transmission by improper application setting
In the standard setting of SWJ-320S, priority is given to the host computer.
Check the settings on the host computer to see if there is any improper parameter setting.
START
Rough identification of error source
Execute appropriate functions or use test
functions of SWJ-320S
Precautions in maintenance
Refer to 7.1.2 List of Error Messages.
Troubles on the host computer side
If this troubleshooting cannot correct the trouble, check to see if the same trouble occurs
with another host computer (if possible).
Do the
above functions operate
normally?
No
Is there error message?
Yes
No
Yes
Trouble due
to the print quality?
Yes
No
Refer to 7.2 Detailed Methods