MIMAKI SWJ-320 S4 - Page 195

© 2013 MIMAKI ENGINEERING CO.,LTD. 7.2.1 P.1
R.1.0
1
2
3
4
5
6
7
8
MAINTENANCE MANUAL > Troubleshooting > Detailed Methods of Coping with the Malfunctions > Sorting process
Model SWJ-320S Issued 2012.07.19 Revised F/W ver 1.0 Remark
1.0
Rev.
7.2.1 Sorting process sheet of ink supply system’s troubles
Check the remaining amount
of ink in the ink bottle.
Check dirt around the cap/
the head.
Check cap leakage.
Perform cleaning after
leaving it for one night.
Perform test drawing to
check nozzle missing.
Perform cleaning several
times.
Normal use
OK
Normal use
Remaining amount
is not enough.
Ink bottle charge
Perform Cleaning of the Wiper,
Cap and Media Press
NG
Clean OK
Perform 7.2.2 Checking of the
cap leak
NG
No leakage. OK
It is possible that fine air remains in the head.
(Flowing ink is not enough to remove them.)
Replace Head
NG
NG
It is a trouble of other than ink
supply system. Check other
than supply system.
OK
OK
Perform test drawing to
check nozzle missing.
NG
OK
Remaining amount OK
Check Ink tank liquid level
Perform 3.1.3 Replacement of
the Ink Supply Pump
NG
Check Ink tank sensor
(
[#TEST SENSOR SUBTANK] )
Perform 3.1.2 Replacement of
the SUBTANK
NG
OK
Perform test drawing to
check nozzle missing.
Execute Ink purge/Ink port
charging
NG
OK
Remaining amount OK