MIMAKI SWJ-320 S4 - Head Cleaning

© 2013 MIMAKI ENGINEERING CO.,LTD. 4.2.1 P.3
4.2.1 HEAD ADJUST
R.1.0
1
2
3
4
5
6
7
8
 Work Procedures
1. Set the media and turn on the adsorption fan.
2. Turn the head height adjustment knob screw and set the head
height to the lowest position.
3. Perform a test print and verify the nozzle condition.
Perform cleaning as necessary.
4. Select [AVERAGING ADJ.] of [#ADJUST / HEAD ADJUST].
[ENTER]: Start
5. Print the adjustment pattern and verify the attachment position
of the heads.
If adjustment is necessary, attach the head attachment jig and
perform adjustment.
 Adjustment/Verification Items
* SWJ-320S4 only
 Do not touch the head connector.
 If the head connector becomes disconnected, turn the power off before reconnecting the connector.
 If the ink supply port at the near side of the head is shaken, the meniscus will be damaged. When
touching the port, do not let it shake.
 If the cap is kept off for a long time, it may result in a skewed ink discharge trajectory or nozzle mis-
alignment. If skewed ink discharge trajectory or nozzle misalignment occurs, the head cannot be
adjusted properly, so do not keep the cap off for a long time.
 In addition, if nozzle misalignment or skewed ink discharge trajectory occurs, perform cleaning.
#ADJUST
HEADADJUST [ENT]
#HEADADJUST
AVERAGINGADJ.[ENT]
#AVERAGINGADJ.
PRINT [ENT]
#AVERAGINGADJ.
**PRINTING**
Head
Adjustments to be performed
Tilt Stagger
Forward/back-
ward position
1
○
--- ---
2
○
---
○
3 *
○○
---
4 *
○ ○ ○
MAINTENANCE MANUAL > Adjustment > Adjustment Items > HEAD ADJUST
Model SWJ-320S Issued 2012.07.19 Revised F/W ver 2.20 Remark
1.0
Rev.