MIMAKI SWJ-320 S4 - Page 61

© 2013 MIMAKI ENGINEERING CO.,LTD. 4.2.5 P.2
4.2.5 [HEAD ADJUST] SLANT ADJUST
R.1.0
1
2
3
4
5
6
7
8
 Head slant check procedure
1. Select [#ADJUST] -> [HEAD ADJUST] -> [SLANT ADJUST]
from the operation menu.
2. Select HEADline1.
3. Press the [ENTER] key to print the pattern.
[ENTER]: starts printing pattern.
[FUNCTION]: Cap OFF
[CLEANING]: Cleaning is curried out.
[]/[]/[]/[]:enters into the jog mode (moves the
origin of the pattern)
 Slant adjustment procedure
1. Confirm whether quantity of biggest gap by each scan is
settled 30 μm. If there is a head whose gap is out of the
standard, carry out the following adjustment.
<LOCAL>
width:1000mm
FUNCTION
#ADJUST [ENT]
#ADJUST
HEAD ADJUST [ENT]
[FUNCTION]
#HEAD ADJUST
SLANT ADJUST [ENT]
#SLANT ADJUST
PRINT START [ENT]
Do not perform this adjustment with the carriage
located on the Station Assy (cap). Make sure to cap
off.
Tolerable range: 30 μm
MAINTENANCE MANUAL > Adjustment > Adjustment Items > [HEAD ADJUST] SLANT ADJUST
Model
SWJ-320S
Issued
2013.03.08
Revised F/W ver 2.20 Remark
1.0
Rev.