MIMAKI SWJ-320 S4 - Page 62

© 2013 MIMAKI ENGINEERING CO.,LTD. 4.2.5 P.3
4.2.5 [HEAD ADJUST] SLANT ADJUST
R.1.0
1
2
3
4
5
6
7
8
2. Loosen the two screws fixing the head to be adjusted.
3. Install the Head adjust tool to the head with the two screws.
4. Turn the adjustment screw of the Head adjust tool. The head
leans to left or right side.
In which direction to turn the screw:
When the head has leaned to left: turn it clockwise.
When the head has leaned to right: turn it counterclockwise.
5. Print the pattern again and examine it.
6. When finished, tighten the two screws to secure the head.
7. Remove the two screws fixing the Head adjust tool, and remove
the tool.
Do not remove!
Head
Head adjust tool
Adjustment
screw
Head
Repeat the adjustment and check with the pattern
until the dots align in the tolerable range.
MAINTENANCE MANUAL > Adjustment > Adjustment Items > [HEAD ADJUST] SLANT ADJUST
Model
SWJ-320S
Issued
2013.03.08
Revised F/W ver 2.20 Remark
1.0
Rev.