MIMAKI SWJ-320 S4 - Page 67

© 2013 MIMAKI ENGINEERING CO.,LTD. 4.2.7 P.2
4.2.7 [HEAD ADJUST] POSITION ADJUST
R.1.0
1
2
3
4
5
6
7
8
 Head position check procedure
1. Select [#ADJUST] -> [HEAD ADJUST] -> [POSITION
ADJUST] from the operation menu.
2. Press the [ENTER] key to print the pattern.
[ENTER]: Starts printing the pattern.
[FUNCTION]: Cap OFF
[CLEANING]: Cleaning is curried out.
[]/[]/[]/[]: enters into the jog mode (moves the
origin of the pattern)
3. Make to take off the cap on the head.
4. Check if the space of pattern 1 is in compliance with the
specification.
Tolerable range: 0 ± 10 μm
When the dots are misaligned exceeding the tolerable range,
proceed to Head position adjustment procedure.
 Head position adjustment procedure
1. Loosen the two screws fixing the head to be adjusted.
2. Install the Head adjust tool to the head with the two screws.
<LOCAL>
width:1000mm
FUNCTION
#ADJUST [ENT]
#ADJUST
HEAD ADJUST [ENT]
[FUNCTION]
#HEAD ADJUST
POSITION ADJUST [ENT]
#POSITION ADJUST
PRINT START [ENT]
Do not perform this adjustment with the carriage
located on the Station Assy (cap). Make sure to take
cap off.
head 1
head 2
Tolerable range:
0 ± 10 μm
Be careful that back and forth positions of dots seen
with a loupe is opposite from the actual position.
Do not remove!
Head
Do not remove the red screws in the figure since they
secure the AD plate and head.
Head adjust tool
MAINTENANCE MANUAL > Adjustment > Adjustment Items > [HEAD ADJUST] POSITION ADJUST
Model
SWJ-320S
Issued
2013.03.08
Revised F/W ver 2.20 Remark
1.0
Rev.