MIMAKI SWJ-320 S4 - Page 85

© 2013 MIMAKI ENGINEERING CO.,LTD. 4.2.18 P.2
4.2.18 FEED COMP.2
R.1.0
1
2
3
4
5
6
7
8
5. Check the adjustment pattern.
Compensation value: -250 ~ 250 (Unit: 2
μm)
[]/[] : Changes adjustment values.
[ENTER] : Registration/To next pattern
6. In the same way, check/adjust other patterns.
More distant than 40μm
Increase adjustment value to “+” direction
due to insufficient adjustment value.
Pattern 0
=0
‑250〜250
OK
NG
More distant than 40μm
NG
Due to a lot of adjustment values, reduce
adjustment values.
If the value of pattern 0 exceeds ±30, check if the
front and back of media does not touch to the
floor, and print the adjusting pattern again.
If the pattern is within ±40 µm, the adjustment is not
required.
Pattern 1
=0
Pattern15
=0
MAINTENANCE MANUAL > Adjustment > Adjustment Items > FEED COMP.2
Model SWJ-320S Issued 2012.07.19 Revised F/W ver 1.0 Remark
1.0
Rev.