MIMAKI SWJ-320 S4 - Page 86

© 2013 MIMAKI ENGINEERING CO.,LTD. 4.2.18 P.3
4.2.18 FEED COMP.2
R.1.0
1
2
3
4
5
6
7
8
 FEED COMP procedure
1. Set Media at X-origin.
2. Select [#ADJUST] -> [FEED COMP 2].
3. Select [FEED COMP], and press [ENTER].
4. Draw an adjustment pattern.
[ENTER] : Executes drawing.
[] : To the screen for adjustment (Without
drawing)
[END] : Completes drawing and inputs compensation
value.
5. Check/Compensate the adjusting pattern.
Compensation value: -9999 to 9999
[]/[] : Changes adjustment values.
[END] : Cancellation of input
<LOCAL>
WIDTH:1000mm
MEDIASET
MEDIARESET [ENT]
FUNCTION
#ADJUST [ENT]
#ADJUST
FEEDCOMP2 [ENT]
When the media is
changed, re-set the width
of media and the height of
head in [MEDIA SET].
DECENTERING
#FEEDCOMP2
FEEDCOMP [ENT]
Set the drawing origin as follows;
(Set in [LOCAL] -> [ORIGIN])
X
≥ 0, Y > 0
When the media is changed, re-set MEDIA
WIDTH and HEAD HEIGHT.
#FEEDCOMP
PRINT [ENT]
Pattern drawing
#FEEDCOMP
**PRINT**
A pattern having
width of media is
drawn.
Compensation value
is too large.
Compensation value
is too small.
#FEEDCOMP
ADJUST=0
‑9999〜9999
OK
NG
NG
For the actual feed compensation, the compensation
value per each feed, which is set in the SETUP func-
tion, is added to this compensation value.
MAINTENANCE MANUAL > Adjustment > Adjustment Items > FEED COMP.2
Model SWJ-320S Issued 2012.07.19 Revised F/W ver 1.0 Remark
1.0
Rev.