Mindray BeneHeart D3 User Manual

3 - 6 Defibrillator/Monitor Operator’s Manual
■ In the AED mode
Press the [High Contrast] soft key to enable the high contrast display. To disable the high contrast display,
press the [Full Color] soft key.
Once [High Contrast] is selected, the high contract display remains when you change the operating mode.
However, the setting will not be saved if the equipment is turned off.
3.3.5 Adjusting Waveform Position
1. Press the Main Menu button on the front panel, and then select [Others >>]→ [Waves >>].
2. Set [Wave 2] and [Wave 3]. [Wave 1] is always ECG1, which is unchangeable.
You can also change waveform position by selecting [Waveform Setup] from the Configuration Main menu.
3.4 Analog Output
The equipment is configured with a multifunction connector for ECG analog output.

Mindray BeneHeart D3 Specifications

General

Type	Defibrillator
Display	Color TFT LCD
Display Size	5.7 inches
Waveform	Biphasic Truncated Exponential (BTE)
Heart Rate Range	15-300 bpm
SpO2 Range	0-100%
NIBP Measurement Method	Oscillometric
Printer Type	Thermal
Paper Width	50 mm
Paper Speed	25 mm/s
IP Rating	IP44
Modes	Manual, AED, Pacing
AED Mode Energy Sequence	150J, 200J
Charging Time	<5 seconds to 200J
Battery Type	Lithium-ion
ECG Monitoring	3-lead
Energy Selection	1-360 J (Manual Mode)