Mindray BeneHeart D3 User Manual

8 - 4 Defibrillator/Monitor Operator’s Manual
◆ Select [Refresh] if there is power failure or CPR is interrupted within five minutes, and then select the
desired CPR event.
NOTE
• A CPR event is automatically saved in the equipment when the interruption time exceeds five
minutes.
• You should select [Refresh] to save a CPR event before disconnecting the CPR sensor from the
equipment.
8.2.5 Uploading CPR Data
If you use the CPR sensor independently, you can connect it to the equipment, and upload the latest one-hour
data to the equipment. You can also review CPR events uploaded from the CPR sensor on the equipment.
For details about CPR event review, refer to 8.2.4Reviewing CPR Events.

Mindray BeneHeart D3 Specifications

General

Type	Defibrillator
Display	Color TFT LCD
Display Size	5.7 inches
Waveform	Biphasic Truncated Exponential (BTE)
Heart Rate Range	15-300 bpm
SpO2 Range	0-100%
NIBP Measurement Method	Oscillometric
Printer Type	Thermal
Paper Width	50 mm
Paper Speed	25 mm/s
IP Rating	IP44
Modes	Manual, AED, Pacing
AED Mode Energy Sequence	150J, 200J
Charging Time	<5 seconds to 200J
Battery Type	Lithium-ion
ECG Monitoring	3-lead
Energy Selection	1-360 J (Manual Mode)