Mindray BeneHeart D3 User Manual

Defibrillator/Monitor Operator’s Manual 10 - 3
10.4.2 Changing Resp Settings
1. Select the Resp parameter area to enter the [Resp Setup] menu.
2. Make the following settings:
◆ Select [Gain] and then choose an appropriate setting. The bigger the gain is, the larger the wave
amplitude is.
◆ Select [Sweep] and then choose an appropriate setting. The faster the wave sweeps, the wider the
wave is.
◆ Select [Lead] to set lead for Resp monitoring.
◆ Select [Apnea Time] to define the time.
10.5 Resp Troubleshooting
For details, refer to EAlarm Messages.

Mindray BeneHeart D3 Specifications

General

Type	Defibrillator
Display	Color TFT LCD
Display Size	5.7 inches
Waveform	Biphasic Truncated Exponential (BTE)
Heart Rate Range	15-300 bpm
SpO2 Range	0-100%
NIBP Measurement Method	Oscillometric
Printer Type	Thermal
Paper Width	50 mm
Paper Speed	25 mm/s
IP Rating	IP44
Modes	Manual, AED, Pacing
AED Mode Energy Sequence	150J, 200J
Charging Time	<5 seconds to 200J
Battery Type	Lithium-ion
ECG Monitoring	3-lead
Energy Selection	1-360 J (Manual Mode)