To Next PageTo Next PageTo Previous PageTo Previous Page
Loading...What to do if my Mindray Diagnostic Equipment system does not work after powering on?
If your Mindray Diagnostic Equipment system fails to power on, try the following: First, power off the system completely. Then, check to ensure the power cable is securely connected to the outlet and verify that the power supply is functioning correctly. Finally, turn the system back on.
Why does my Mindray DP-10 Diagnostic Equipment screen display characters but no images?
If your Mindray Diagnostic Equipment screen shows characters but no images, check these items: Ensure the transducer is properly connected to the system. If the image is frozen, unfreeze it. Adjust the image by turning the gain knob or pressing TGC keys. If the screen still shows no images, power the system off, wait at least 10 seconds, and then power it back on.
What to do if the screen of my Mindray Diagnostic Equipment displays abnormally?
If the screen display of your Mindray Diagnostic Equipment is abnormal, turn off the system, wait for at least 10 seconds, and then turn it on again.
What to do if my Mindray Diagnostic Equipment system works but the screen does not display anything?
If your Mindray Diagnostic Equipment system is running but the screen remains blank, try these steps: First, adjust the screen's brightness and contrast using the brightness and contrast knobs. If the screen remains blank, power off the system, wait at least 10 seconds, and then power it back on.
What to do if my Mindray DP-10 image is abnormal?
If the image on your Mindray Diagnostic Equipment appears abnormal, try selecting a proper exam mode and adjust the image.
General| Gray Scale | 256 levels |
|---|---|
| Weight | 5.5 kg |
| Imaging Modes | B, B/B, 4B, M |
| Frequency | 2.0 to 10MHz (depending on the transducer) |
| Cine Loop | 256 frames |
| Power Supply | AC 100-240V, 50/60Hz |
| Image Storage | Built-in storage, USB flash disk |
Explains the layout and function of the system's control panel keys.
Introduces the software interface and how to operate its elements.
Instructions for connecting the system's power plug to a suitable outlet.
Details on connecting the equipotential terminal for safety.
Procedure for connecting and disconnecting transducers to the system.
Step-by-step guide for safely starting the ultrasonic system.
Procedures for properly shutting down the ultrasonic system.
Guide on entering patient data for accurate diagnosis and record-keeping.
How to choose the appropriate exam mode for different examinations.
Details on adjusting parameters like gain, acoustic power, and frequency.
Outlines the general steps for performing measurements.
Procedure for saving image files to a storage device.
Procedures for cleaning and disinfecting transducers.
Information and warnings related to using the biopsy guide.
Procedures for cleaning and sterilizing needle-guided brackets.
Describes routine maintenance tasks performed by the system user.
Details maintenance tasks performed by trained service personnel.
