4-1
4 Preset
This chapter briefly describes how to preset the system. Refer to the Advanced Volume for
details.
The preset function is used to set the operating status, configuration parameters of each
exam mode, post process and others. The system runs automatically with the preset
parameters after each startup. Before examining patients, ensure proper parameters have
been preset.
1
Press <Setup> and then the [PRESET] menu pops up.
2
Preset parameters.
3
After all preset is completed, press <Esc> or select [Return] in the [PRESET]
menu to close the [PRESET] menu. The system runs with the modified preset
data.
Note that the modified preset data takes effect only after the preset status exits
using the above method.
To Next Page
Loading...
Need help?
General
