Mindray DP-10 User Manual

System Connection
2-4
NOTE:
If you remove the USB connector from the USB port directly without
performing the steps above, the USB storage device and the system may
be damaged.
To connect a video printer
1 Turn off the system and the printer.
2 Use the data cable of printer to connect the “VIDEO IN” port on the printer and the
video output port on the system.
3 Use the power cord of printer to connect the power input port on the printer and the
receptacle.
To connect a graph/text printer
1 Turn off the system and the printer.
2 Use the USB data cable of printer to connect the USB ports on the printer and on the
system.
3 Use the power cord of printer to connect the power input port on the printer and the
receptacle.

Mindray DP-10 Specifications

General

Gray Scale	256 levels
Weight	5.5 kg
Imaging Modes	B, B/B, 4B, M
Frequency	2.0 to 10MHz (depending on the transducer)
Cine Loop	256 frames
Power Supply	AC 100-240V, 50/60Hz
Image Storage	Built-in storage, USB flash disk