39
Service Manual Combics
Test Results
If the test program detected an error, then this is also shown at the end of the test on the
display.
If the program discovers multiple errors, then these are all shown on the display contrary to
Combics 2.
Caution
3
If the display flashes, then the key to cancel the test was pressed accidentally.
Disconnect the device from the power - pull the plug.
Then reconnect the power plug and turn the device back on via the e key.
The device is ready for operation again.
t Press the e key to exit the program.
Operating Design | Test Program Combics 3
To Next Page
Loading...
