2 Safety instructions
2.1 General information
CAUTION
Warning of personal injury.
The product was in perfect condition with regard to safety features when it left the
factory.
To maintain this condition and to ensure safe operation, the user must follow the
instructions and observe the warnings in this manual.
2.2 Intended use
The device is intended for use as an indicator for weighing functions.
Product operation, commissioning and maintenance must be performed by trained and
qualied personnel who are aware of and able to deal with the related hazards and take
suitable measures for self-protection.
The device reects the state of the art.
The manufacturer does not accept any liability for damage caused by third-party system
components or due to incorrect use of the product. The use of this product signies
recognition of the stipulations listed above.
2.3 Incoming goods inspection
The shipment must be checked for completeness. A visual inspection must be performed
to determine if the shipment has been damaged. If there are grounds for a complaint, this
must be brought to the attention of the delivery company immediately. A Minebea Intec
sales or service point must be informed.
2.4 Before operational startup
NOTICE
Perform visual inspection!
Before operational startup as well as after storage or transport, inspect the device
visually for signs of mechanical damage.
2.4.1 Installation
The device is designed for mounting rail installation (35 mm as per DIN 46277).
NOTICE
Excessive heat may reduce the device lifetime.
When mounting on the rail, make sure that the distance from other instruments left
and right of the device is at least 20 mm.
2 Safety instructions Transmitter Series PR 5220
EN-9 Minebea Intec
To Next Page
Loading...
Need help?
General
