175174
CUSTOM 19, 20
To set custom functions;
1.Open control-panel door and press the CUSTOM button.
2.Turn the front control dial to select the desired custom function.
3.Turn the rear control dial to seclect the setting.
4.Press the shutter-release button partway down to enter the setings.
Refer to pages 154-157 for additional information.
Custom 19 - Control Dial - Exchanged Control
1. Unchanged from Custom 18.
This custom function allows you to switch the operations of the front
and read control dials.
2. Front and rear control dial functions
exchanged.
• Control dial tasking does not change for brack-
eting, data memory, and custom functions.
Custom 20 - Flash Metering
2. TTL 4-segment
When flash fires, TTL 4-segment metering will be used.
• Recommend TTL 4-segment metering if using a flash/color meter,
close-up diffuser, or filter.
3. TTL Average
When flash fires, TTL average metering will be used.
Your camera uses ADI flash metering as the
standard flash metering mode, but it can be
changed.
• This applies to both the built-in and accessory
flash.
• When full auto is selected, if possible, flash
metering is always ADI, even if Custom 20-2/3
is selected. If not possible, due to a flash/lens
combination, TTL 4-segment flash will be used.
1. ADI 4-segment
When flash fires, ADI 4-segment or pre-flash metering will be used.
• For more information see page 108.
Control Dial Tasking
PS - shutter speed
Aperture
Shutter speed
Front Control Dial Rear Control Dial
Exposure
Mode
P - Mode
A - Mode
S - Mode
Exposure
compensation
3.
Exposure compensation using rear control dial (P
S
- shut-
ter speed in P mode)
In P/A/S mode, exposure compensation is possible using the rear
control dial.
• Exposure compensation, using the rear control dial, is the same as for
setting 2. Please refer to the notes in setting 2.
• If you turn the front control dial in P mode, you can select the shutter
speed.
CUSTOM FUNCTIONS
4-segment metering
To Next Page
Loading...
Need help?
General
