183182
Focus
AF-A (Autofocus priority)
Focus area
Wide focus area
Metering
14 Segment honeycomb
Exposure compensation
+/- 0
Flash compensation +/- 0
Drive Single frame advance
Item
Standard Settings
The camera’s standard settings are shown in the chart below.
To set custom functions;
1.Open control-panel door and press the CUSTOM button.
2.Turn the front control dial to select the desired custom function.
3.Turn the rear control dial to seclect the setting.
4.Press the shutter-release button partway down to enter the setings.
Refer to pages 154-157 for additional information.
CUSTOM 26, 27
Custom 27 - Detailed Display
1. Show all settings.
Select this setting if you want all the settings
to be shown in the display.
2. Show only the changes from the stan-
dard settings.
Use this setting when you feel that the display
is too crowded with all settings shown.
• The standard settings will not be shown, only
those that have been changed.
• The standard settings are shown on the next
page.
Standard settings A mode with spot
metering, and exposure
compensation
Same plus flash is
raised and bracket-
ing selected
• When Custom 27-2 is selected, an exposure compensation of 0.0 will
not appear in the large icon display.
• The exposure-mode indicator and battery-condition indicator appear
all the time.
2. Fixed burst
When the flash fires and exposure compensation is set, only the
aperture/shutter-speed change to compensate the exposure. The
flash burst is fixed. Exposure within the flash range remains almost
the same.
1. Varied burst
When the flash fires and exposure compensation is set, both the
flash burst and the aperture and shutter-speed change to compen-
sate the exposure.
• Exposure compensation is done for subjects both in and outside the
flash range area.
CUSTOM FUNCTIONS
To Next Page
Loading...
Need help?
General
