37
Front Panel Menu Operation
At this point the display varies, depending on your choice:
• If you selected “yes”, the display shows either the message “Zone bypassed” or “Zone
unbypassed”, then it returns to the Command Menu.
• If you selected “no”, the display shows the message “Operation cancelled”, then it
returns to the Command Menu.
5.2.7 Unbypassing an active zone
When you unbypass an input zone that went into alarm while it was bypassed, the following
message appears:
If you select “yes” to unbypass this zone, the system immediately goes into alarm. To avoid
this problem, press the System Reset button before unbypassing the zone.
5.2.8 Output Zone
Use this option if you want to bypass an entire zone of addressable devices from the panel.
Usually this is done during building maintenance.
Step 2: Select a node
1. Use and to select the node number.
2. Press to continue.
Step 3: Select a zone
1. Use and to select the zone.
2. Press to continue.
Step 4: Bypass the zone
The system asks whether or not you want to bypass
or unbypass the input zone.
1. Use and to select “yes” or “no”.
2. Press to continue.
Warning: Bypassing an output zone disables all devices in that zone.
- Select Zone -
Tag 1
Tag 2
01-**-**IZ-0001
Warning: This zone is
active. Do you really
want to unbypass
it? Y
To Next Page
Loading...
Need help?
General