FX-350/351 Series Programming Manual
31
The user can press UP and DOWN key to scroll through all the devices on the loop for which the verify count is
available. If there are no verified devices on the loop the following message will be displayed.
Operation Menu/Reports/5. Maintenance report
The user is prompted to enter the loop no of the device to which it is connected.
The maintenance report is shown in the following format.
The user can press UP and DOWN key to scroll through all the devices on the loop for which the maintenance
report is available. If there are no dirty devices on the loop the following message will be displayed
OPERATION MENU/4. CLEAR LOGS
Clears the logs stored in the flash memory
The options are to clear only the alarm logs, event logs or all the logs. The user is prompted for confirmation
After confirmation the logs are cleared and the following information message is displayed.
OPERATION MENU/5. WALK TEST
Selecting Walk Test on the command menu allows the user to initiate a silent or audible Walk Test. The user is
prompted to select the audible or silent walk test.
After the user makes a selection the following message will show the walk test initializing.
Entering walk test, places the system in trouble. The trouble is non-latching and is cleared when walk test is
exited. Walk test is aborted by pressing the Cancel button. It will also be aborted if no circuit activations are
No verified devices
found
Loop Number
Loop :__
Maint Report
Percent dirty :012%
No dirty devices
found
6HOHFW/RJ
$ODUP/RJ
*HQHUDO/RJ
$OO/RJV
Clear all the
Selected log (s)?Y/N
Log(s) cleared
Select Test Type
1. Audible Test
2. Silent Test
Initializing
Walk test ...
To Next Page
Loading...
Need help?
General
