Command Mode - Configuration & Operation
22
prompted to enter the zone LED number as shown below.
PANEL CONFIGURATION/5. REMOTE SWITCHES
Remote switch configuration allows the user to associate any input, configured as remote switch, to be associated
with the following common control switches.
Selecting system reset will display the following message if there is no input circuit associated with the switch
If there is input circuit(s) associated with the system reset the list of the associated input circuits is displayed. The
circuits are recognized by the Loop# and the device address as shown below
The user can press RIGHT arrow key to add and LEFT arrow key to delete an input circuit. When a user deleted an
input circuit, after the confirmation, the circuit is deleted and the list is updated. When the user adds an input circuit
the user is prompted to add an input circuit.
The operation is true for all the 7 common control switches except that the switches are different.
CONFIGURATION MENU/2. AUTO CONFIGURATION
Auto configuration automatically detects devices and their addresses, if no changes are found during the scan of the
loop the following message is displayed
If new devices are found on the loop the user is prompted for the fact and prompt for confirmation to add the new
devices as shown below
If the devices are missing
Note: Associating a bypass group to an LED is not mandatory. Check with the local AHJ.
------ Led map ------
Zone Led No :__
--Remote switches --
1. System reset
2. Fire Drill
3. Aux disconnect
4. Buzzer silence
5. Signal silence
6. Acknowledge
7. General Alarm
---System reset ----
empty
---System reset ----
Lp:01 DevAddr :006
Lp:01 DevAddr :008
Lp:01 DevAddr :010
Ipt Dev Loop # & Addr
Loop :__ DevAddr :___
No changes found .
Auto program aborted
XXX new device (s)
found on loop . Add?
Xxx device (s) are
Missing . Delete ?Y
To Next Page
Loading...
Need help?
General
