Mitel 6869 SIP - Page 40

40 Mitel 6867 SIP / Mitel 6869 SIP
eud-1664/2.0 – R6.0 – 06.2018
Phoning
Dialing with a configurable key/ busy lamp field
You want to call someone whose phone number is stored under a configu-
rable key or a busy lamp field.
To find out how to configure a configurable key, refer to chapter "Configur-
ing keys", page 97.
Dialing with the line key
You can make a call through a line key.
Your phone is equipped with two dedicated line keys with LED (L1, L2).
Your system administrator can set up to seven additional line keys (nine in
total). The actual number of line keys depends on the system configura-
tion. Press a dedicated line key directly or select a line by pressing the hor-
izontal right navigation key. The display shows the dialed line number (L1,
L2 etc.). If a line is free, then the New Call softkey at the bottom left of the
display can be used
Your system administrator can set up to ten additional line keys (twelve in
total). The actual number of line keys depends on the system configura-
tion. Press a set line key directly or select a line by using the horizontal
right navigation key. The display shows the dialed line number (L1, L2
etc.). If a line is free, then the New Call softkey at the bottom left of the dis-
play can be used.
You can switch the line by pressing the key. The active call is automatically
put on hold locally.
Line keys are stored on configurable keys by your system administrator
(see chapter "Line keys on a key telephone", page 79
).
Phoning with the handset:
1. Pick up the handset.
2. Press the desired configurable key/busy lamp field.
➔The phone number is dialed.
Using your phone in hands-free mode:
Press the desired configurable key/busy lamp field.
➔The phone number is dialed.