Mitel 6869 SIP - Page 53

Phoning
Mitel 6867 SIP / Mitel 6869 SIP 53
eud-1664/2.0 – R6.0 – 06.2018
Activating discreet ring
You do not want to be disturbed by the ring of the phone. You do not, how-
ever, want to switch off the phone.
As an alternative to the usual ring, your phone has a discreet ring option. If
you have activated discreet ring, the phone only rings once.
This function must be saved to a function key over the Self Service Portal
(see chapter "Configuring or deleting a key assignment", page 99
).
Activating do not disturb
You do not want to receive any calls for the time being.
With the do not disturb function, you can stop calls being made to you if
you are busy or are not otherwise able to take any calls. Your phone does
not ring and is set to busy for incoming calls. Your incoming calls are auto-
matically forwarded to a call forwarding destination that has been config-
ured by your system administrator.
Your system administrator must enable this function in the MiVoice
Office 400 communication system.
This function must be saved to a function key over the Self Service Portal
(see chapter "Configuring or deleting a key assignment", page 99
).
Stopping the call:
End the recording by pressing the function key Call recording: start/stop again.
➔The recording is sent to your e-mail address.
Note: The LED on the function key remains lit while the recording is in progress. The
LED starts to flash before the recording reaches its maximum preset duration.
Once the maximum duration is reached (or the memory is full), the recording is
stopped and the LED goes off.
Activating/deactivating discreet ring:
Press the function key for Discreet ring on/off.
➔The function is activated/deactivated, is displayed and the LED on the
function key lights up/does not light up.