3-96 Operation of the initial-setting screen
3Explanation of operation methods
6) Press the [F1] key, and save the setup.
If not saved, press the [F2] key. All return to the initial-setting screen.
And, the setup can be done over again if the [EXE] key is pressed.
7) T/B starts in the contrast set up when the [EXE] key was pressed.
1.Save and Exit
2.Exit without Save
<1> <2> Prev
1.Configuration
2.Com.Information
<1> <2> Rset
1.Configuration
2.Com.Information
<1> <2> Rset
MELFA CR75x-D Ver. S3
RH-3FH5515-D
COPYRIGHT (C) 2011 MITSUBISHI ELEC
TRIC CORPORATION ALL RIGHTS RESE
RVED
To Next Page
Loading...
