1. INTRODUCTION
--------------------
MELSEC·A
(8) Can be mounted to
the
DIN rail.
The A2C and A2CI/O modules are usually mounted directly
to
a control I
panel or equipment to be controlled using screws. Using
the
DIN rail
adapter, however, the A2C modules can be mounted to
the
DIN rail.
(A clearance of 4 mm (0.16 in) between modules is obtained when
the
DIN adapters are mounted side by side without leaving clearance
between them. (See App. 1.)
HOOK for removing the
DIN rail adapter
module from the DIN
A2C
A2CI/O
module
/Nrall
V-;;;N
rail
-.
0
=
-
V
-
r---
1[1
-
\
t
=
r----f
\
tr
0
~
~
Fig.
1.7
A2C
and
A2CI/O
Modules
Mounted
to
the
DIN Rail
1-8
To Next Page
Loading...
