IMPORTANTI
")
The components on the printed circuit boards will be damaged by static electricity, so avoid
, handling them directly. If it is necessary to handle them take the following precautions.
(1) Ground human
body
and
work
bench.
(2) Do not touch the conductive areas of the printed circuit board and its electrical parts with any
non-grounded tools etc.
Under no circumstances will Mitsubishi Electric be liable or responsible
for
any consequential
damage that may arise as a result of the installation or use of this equipment.
All examples and diagrams shown in this manual are intended only as an aid to understanding the
test, not to guarantees operation. Mitsubishi Electric will accept no responsibility for actual use of
the
product
based on these illustrative examples.
Owing to
the
very great variety in possible applications of this equipment, you must satisfy yourself
as to its suitability
for
your specific application.
To Next Page
Loading...
