347
CHAPTER 4 DEVICES
4
4.2 Internal User Devices
4.2.1 Input (X)
● When debugging a program, the input (X) can be set to on or off by the following:
• Device test using a programming tool
• OUT Xn instruction
● The input (X) can also be used for the following.
• Refresh target device (CPU module side) of RX in CC-Link IE Field Network, CC-Link IE Field Network Basic, or
CC-Link
• Refresh target device (CPU module side) of CC-Link IE Controller Network or MELSECNET/H
X1
OUTX1
ON/OFF command
To Next Page
Loading...
