Mitsubishi Electric MELSEC-Q00U(J)CPU

440
Appendix 1.2.3 PLC file
Parameters required for the files used in the CPU module are set.
*1 Not available for the Q00UJCPU.
Item
Parameter
No.
Description Setting range Default Reference
File Register
*1
1100
H
Set a file for the file register used
in the program.
• Not Used
• Use the same file name as the
program.
• Use the following file.
Not Used
Page 390,
Section 4.7
Transfer to Standard ROM at
Latch data backup operation
*1
1104
H
Select whether to batch-transfer
the data in the file register at the
time of latch data backup to the
standard ROM.
Checked/unchecked Unchecked
Page 253,
Section 3.29
Comment File Used in a
Command
1101
H
Set a file for device comments
used in the program.
• Not Used
• Use the same file name as the
program.
• Use the following file.
Not Used -
Device Initial Value
1102
H
Set a file for initial values of the
devices used for the CPU module.
• Not Used
• Use the same file name as the
program.
• Use the following file.
Not Used
Page 246,
Section 3.25
File for Local Device
*1
1103
H
Set a file for local devices used in
the program.
• Not Used
• Use the following file.
Not Used
Page 420,
Section 6.2
File used for
SP.DEVST/S.DEVLD Instruction
1105
H
Set a device data file used for
writing to or reading from the
standard ROM.
• Not Used
• Use the following file.
Not Used
Page 258,
Section 3.30