Mitsubishi Electric NZ2MFB2-16A - Function List; List of Functions of each Module

62
3 SPECIFICATIONS
3.3 Function List
3.3 Function List
This section lists the functions of I/O modules.
3.4 List of Functions of Each Module
This section lists the functions of each module.
: Available, : Not available
Item Description Reference
Input function The ON/OFF status (X signal) of inputs is notified to Remote input (RX) of the master
station.

Output function The ON/OFF status (Y signal) of outputs is controlled with Remote output (RY) of the
master station.

Input response time setting function This function prevents an incorrect input due to noise by setting the response time
until the module recognizes an actual input as the X signal.
Page 90 Input Response
Time Setting Function
Output HOLD/CLEAR setting function When the I/O module is disconnected from data link, or the CPU module operating
status is STOP, whether to hold or clear the last output value can be set by this
function.
Page 91 Output HOLD/
CLEAR Setting Function
Protection function The overload protection function and overheat protection function protect the internal
circuit from overcurrent and its heat.
Page 92 Protection
Function
SLMP communication function SLMP can be used to communicate with the I/O module. Page 93 SLMP
communication function
Model name Input function Output function Input response
time setting
function
Output HOLD/
CLEAR setting
function
Protection
function
SLMP
communication
function
NZ2MFB2-16A 
NZ2MF2S2-16A 
NZ2MFB1-32D 
NZ2MF2S1-32D 
NZ2MFB2-16R 
NZ2MF2S2-16R 
NZ2MFB1-32T 
NZ2MF2S1-32T 
NZ2MFB1-32TE1 
NZ2MF2S1-32TE1 
NZ2MFB1-32DT 
NZ2MF2S1-32DT 
NZ2MFB1-32DTE1 
NZ2MF2S1-32DTE1 