82
6 INSTALLATION AND WIRING
6.5 Wiring
■Connecting and disconnecting the cable
To connect the cable, fully insert a wire having a bar solderless terminal into a wire insertion opening.
After inserting the wire, pull it lightly to check that it is securely clamped.
Continuity can be checked with test terminal (1).
To disconnect the cable, push in the open/close button with a Phillips screwdriver or flathead screwdriver.
With the button pushed in, pull out the wire having a bar solderless terminal.
■Precautions
• Use a bar solderless terminal for the wiring to the spring clamp terminal block. If a stripped wire is inserted into a wire
insertion opening, the wire cannot be securely clamped.
• For how long the wire should be stripped, follow the specifications of the bar solderless terminal used. To attach a bar
solderless terminal to a wire, use a crimping tool.
• Before inserting a bar solderless terminal into a wire insertion opening, check the shape of the opening and the shape of
the terminal. Insert the terminal paying attention to the orientation. If a bar solderless terminal larger than the wire insertion
opening is inserted, the terminal block may be damaged.
To Next Page
Loading...
