Mitsubishi 00JCPU - Page 375

8 - 34
CHAPTER8 PARAMETERS
1
2
3
4
5
6
7
8
8.4 Remote Password
8.4 Remote Password
This section provides the list of parameters for use of remote password and describes parameter details.
A remote password is set for an Ethernet module, serial communication module, or modem interface module.
Figure 8.30 Remote password settings dialog box
Table8.33 Remote password setting list
Item
Parameter
No.
Description Setting range Default Reference
Password settings - Enter a remote password.
Four characters or less
(alphanumeric characters, special
symbols)
-
• QJ71E71:
Ethernet module
manual
• QJ71C24: Serial
communication
module manual
• QJ71CMO:
Modem interface
module manual
Password
active
module
settings
Model
name
-
Select a model name of the module
for which the remote password set to
the CPU module is checked.
QJ71E71
QJ71C24/CMO
-
Start XY -
Set the start address of the module
for which the remote password is
checked.
• Basic model QCPU:
0000
H to 03E0H
• High Performance model QCPU,
Process CPU, and Redundant
CPU: 0000
H to 0FE0H
-
Detail -
Set details of the remote password for
the QJ71E71.
--
User connection No. - Select user connection No. Connection 1 to Connection 16 -
System connection -
Select a valid port of the remote
password for system connection.
Specify a valid port of the remote
password.
Auto open UDP port
FTP transmission port (TCP/IP)
GX Developer transmission port
(TCP/IP)
GX Developer transmission port
(UDP/IP), Dedicated instruction,
CC IE Control, MNET/10(H) relay
transmission port.
HTTP port
-