Mitsubishi FREQROL-U100 User Manual

• When alarm (Er 1 to 3) is displayed
(The alarm can be canceled by pressing the mode key. not canceled by
RESET
key.)
Alarm
Type Details
display
E, I
Write prohibit alarm
Writing was attempted during the pr.77 M1
M
state (write prohibit)
E,'
Write alarm
Pr.79 was rewritten or all clear was executed during operation.
during operation
Ed
Calibration error The calibration value for C-2 and C-3 was too close,
.
(Note)
1) Pressing UP or DOWN key will increment
or decrement displayed parameter number
by one in order of the parameter list.
(PO will display if the UP key is pressed
when ct.r is displayed.)
2) The current monitor displays only when
the SET key is pressed in the frequency
monitor mode.
press~.
r-il The setting value of the selected
L---!..J parameter will display.
I @:Change with the UP or DOWN key.
Set the
parameter satting value.
D······ (The displ8y will flicker until the
setting is completed. )
prass§.
(
IlliJ) . .
U The parameter settmg IScompleted.
Flickers alternately.
• The calibration error Will occur If the difference of the Input voltage for the C-2 to C·3 calibration
value is approximately
O.5V or less.
-22-

Mitsubishi FREQROL-U100 Specifications

General

Brand	Mitsubishi
Model	FREQROL-U100
Category	Inverter
Language	English