Mitsubishi FREQROL-U100

• Upper limit frequency rn •Lower limit frequency rn
The upper and lower limit clamps of the output frequency can be set.
• Explanation of functions
• Torque boost (manual) [[]
The Jaw frequency band motor torque can be adjusted to the load.
-25-
lOO%~ '~
..•..• :~it frequency setting range
Output :
frequency ,
.•.••. :
Lo1wer limit frequency setting range
o- ,
Frequency 5V
setting signal
[Factory setting)
Torque boost (manual) 6 %
(Note)
If the setting value is too large. the overcurrent protective
function may activate. The setting value can be adjusted
while confirming the
motor current with the monitor function.
[Factory setting)
• Upper limit
frequency"""120Hz
• Lower limit
frecuencv-. ... 0 Hz
O~::~~-·----·---··-1
""""?T
Settingr . [
range :
Output Base
frequency (Hz) frbQuency