Mitsubishi FREQROL-U100 - Page 9

LhWARNING
.6'; Do not use a contactor in the inverter input for frequent start
/stopping of the inverter. use control signals .
.6'; To reduce the effect of mains conducted electromagnetic
interference use a RFI noise filter.
.6'; Take care to ensure electromagnetic radiation from the
inverter does not damage or effect the operation of nearby
electrical equipment.
.6'; Use an input line reactor when the power supply capacity is
large.
or where harmonics from the inverter will cause
problems .
.6'; Take countermeasures to prevent motor insulation damage
from micro surge voltages in the supply cable.
.6'; Reset the inverter before starting set-up. initialises the
parameters to factory set values.
.6'; Do not use the inverter and motor at high speed until the
machine has been checked.
.6'; The inverter does not have a holding stop facility. For
emergency stop another circuit must be used.
A-7