17
• The unit of tension (N or × 10N) and the decimal point position are determined by setting the parameter.
• The DISPLAY SELECTOR (TENSION /OUTPUT) switches over the tension display and output display.
• On the screen of Tension set, Stall set, New reel set, Taper ratio, the internal setting or the external setting
which is effective is displayed on the screen. When the external setting is effective, "EXT." is displayed on
the screen.
O U T P U T → # # # %
N W R . S E T
S E T → # # # %
E
O U T P U T → # # # %
T P E R S E T
S E T → # # # %
A
% : C N R 2 # # # # m m φ →
T P E R S E T
C N R 1 # # # # m m φ → T P R . 1 # # #
A
%:
T P E R S E T
C N R 4 # # # # m m φ → T P R . 4 # # #
A
% T P R . 3 # # #
New reel set ( When multi-shaft mode is selected. )
T N S N . → # # # # N
N W R . S E T
S E T → # # # %
E
ST
Linear taper set ( When taper is selected. )
T N S N . → # # # # N
T P E R S E T
S E T → # # # %
A
Nonlinear taper set ( When non linear taper is selected.)
X
W
O U T P U T → # # # %
D A . M N T .
D I A . → # # # # m m φ
I
T N S N . → # # # # N
D A . M N T .
D I A . → # # # # m m φ
I
Reel diameter monitor (When reel diameter input is used .)
To Next Page
Loading...
