51
11.5 Outside dimensions and general specification
Accessories Weight : Approximately 3.5 kg
Main unit mounting plate : One pair Painting color : Munsell 7.5Y 7.5/1
Screws fixing main unit and mounting legs : M4 × 10 ,4screws
Screws of 10 mm or more are not applicable because
such screws may make contact with parts inside the
main unit.
When the unit is installed on the floor or wall, use
these screws to fix the main unit and mounting legs.
Ambient temperature
0 ~ 40
°c during operation
Ambient humidity 80% RH or less ( no condensation) during operation
Vibration resistance
10 to 55 Hz, 0.5mm (4. 9m / s
2
maximum), 2 hours in each of three axis directions.
Impact resistance
98m / s
2
, 3 times each of three axis directions.
Supply noise resistance
By noise simulator with 1,000 Vp-p noise voltage, 1 µs noise width and 30 to 100 Hz
cycle.
Withstand voltage 1,500V AC, 1 minute
Entire terminals as a whole andbetween the
ground terminal.
Insulation resistance 5MΩ or more by 500V DC megger
Grounding Solid grounding (100Ωor less)
Operating atmosphere No corrosive gas and little dust
Power switch cycles Less than 20,000 times
1. Outside dimensions
246
228
244
256
156
16.5
140
16
15
80
100
80
100
148
20 or less
512
－Ｅ
OUTP UT
ON/OFF
POWER
ON
OFF
EN TER
CANCEL
INC/DEC
PAGE
CURSOR
MODE
MANUAL
AU TO
TENSION SET MANUAL SET
MON ITOR
SELECT
2. General and environmental specifications
To Next Page
Loading...
Need help?
General
