15
5.3 Calling up engineer screen
• Follow this operation to make changes from the state of initial setting.
• Enter the password on the password screen. Press the enter key to enter the engineer screen.
S
X
W
Enginneer screen
P S S W O R D
S E T → # # # # # S E T N U M B E R
A
S T T I N G S E L E C T M E N U B Y C U R S O R
S W I T C H : T E N S I O N : S T R T S T P : R E E L C H G :.
E
Reel diameter
monitor or tension
monitor screen.
Complete
initial setting
T T
Numeric input
4095
¾
Error input
message
¾ Enter"4095" or the value
registered in the initial
setting as the password
(Refer to page 8.)
ENTER
T
ST
Seting screen
For setting of these items,refer to the initial setting.
T
M E N U : O T H E R : G A I N
S T T I N G S E L E C T M E N U B Y C U R S O RE
R E E L C H G :
The control output by the manual torque and the stall setting are set
by the following standard.
Dmax : Maximum diameter
D : Diameter
F : Control tension
D0 : Initial diameter
F : Average drive tension
Feed control Feed control
Manual
torque
Stall
New reel preset
F
N = × 100
F
max
~
F
N = × 100
F
max
D
0
F
0
N = • × 100
D
max
F
max
~
D F
N = • × 100
D
max
F
max
Ratings torque of actuators
Fmax = × The maximum drive tension
The maximum use torque of actuators
• Obtaining stall value and new reel torque by operating actual machine
Operate the machine in automatic control mode with the target tension . Display the
output on the output indicator (4-digit, 7-segment display ).
Read the output value where the reel diameter is close to the initial diameter . It is
recommended to use this value as the stall value .
Standard of volume set output
To Next Page
Loading...
Need help?
General
