16
5.4 Display of operator screen
The usual operations (setting operations) are performed on the following screen.
Automatic
Operation
Mode selected
Tension set
• The bar graph in the upper right corner always
indicates the detected tension (%). The "100%"
indication corresponds to the full -scale tension.
• This is to enter the stall
values .
Refer to pages 13 and 14
for more about the stall
functions.
ST
Manual
Operation
Mode selected
T S N . S E T M N T . →
S E T → # # # . # × 10 N →
N
T S N . S E T M N T . →
S E T → # # # # N →
N
S A L L S E T
S E T → # # # % O U T P U T → # # # %
T
S A L L S E T
S E T → # # # % T N S N . → # # # # N
T
ST
• This displays the set
tension.
• The unit of tension such
as "×10N" and " N " and
the position of the
decimal point are
determined depending on
the parameter setting .
Stall set
When new reel and taper
functions are in use .
Manual setting
Total tension monitor
Tension monitor left and right
O U T P U T → # # # %
M N U . S E T
S E T → # # # %
A
T N S N . → # # # . # × 10 N
M N U . S E T
S E T → # # # %
A T N S N . → # # # # N
M N U . S E T
S E T → # # # %
A
ST
T S N . M N T .
T A R G E T → # # # . # × 10 N →
N
T S N . M N T .
T A R G E T → # # # # N →
N
T S N . M N T . L E F T → # # # . # × 10 N
R I G H T → # # # . # × 10 N
N
T A R G E T → # # # . # × 10 N
T S N . M N T . L E F T → # # # # N
R I G H T → # # # # N
N
T A R G E T → # # # # N
ST
ST
Password
screen
• Sets the operation torque
for the manual operation .
Refer to page 15 for the
guideline of setting .
• Displays the tension or
the output by the
tension/output select
switch on the panel.
• When carrying out the
taper control , the taper
ratio is taken into the
"target (target tension )"
value.
• This displays the left and
right tension
measurement . This
allows to check whether
the tension in the material
is balanced.
Use of reel diameter input
To Next Page
Loading...
