Mitsubishi MELDAS MDS-C1 - Page 55

2. Wiring and Connection
2 - 22
(3-1) Connection for full-closed synchronous control
(when using MDS-C1-V1 drive unit and serial output linear scale)
MDS-C1-V1
(Slave axis)
MDS-C1-V1
(Master axis)
MDS-B-SD
Signal distribution unit
Linear scale
CN2
CN3 CN2 CN3
CN3B
CN3A
CN3
Master axis
Slave axis
Detector cable
CNV12
Parameter settings
No. Abbrev. Parameter name Description
Set the detector type. (Refer to Chapter 3 Setup for details)
Speed command synchronous control : D0xx or D1xx or D2xx
Master axis Speed command synchronous control : A0xx or A1xx or A2xx
SV025 MTYP Motor/detector type
Slave axis Speed command synchronous control : D0xx or D1xx or D2xx
(Note) The full-closed system using two MDS-C1-V1 units is not compatible with current command synchronous control.