IMPORTANT
1
The components on the printed
circuit
boards
will
be
damaged by
static
electricity,
so
avoid
handling them directly.
tf
it
is necessary to handle them take the following
precautions.
(1)
Ground human
body
and work bench.
(2)
Do
not touch the conductive areas of the printed circuit board and
its
electrical parts
with any non-grounded tools
etc.
Under no circumstances will Mitsubirhi Electric be liable or responsible for any consequential damage that may
arise
as
a result of the installation or use of this equipment.
All examples and diagrams shown in this manual are intended only as an aid to understanding the text, not to
guarantee operation. Mitsubishi Electric will accept no responsibility for actual use of the product based on these
illustrative examples.
Owing to the very great variety in possible applications of this equipment, you must satisfy yourself as to its
suitability for your specific application.
I6
INAi
66101-A
To Next Page
Loading...
Need help?
General
