Mitsubishi MELSEC-A series - Drive Unit Connector

5.4.2 Drive unit connector
F Cable ClmD
I
Fig. 5.1 Connector
See Section 3.7, page 3-54 for pin details.
(1) Use 0.3mm2 wire.
(2) Solder the wires to the pins and finish with insulating tubing.
3-
Pin arrangement seen from top.
Connector
pins are "Al" to
"A20" and
"Bl" to "820."
Fig. 5.2 Connector
5-6
IB INN 66101.A