Mitsubishi MELSEC-A series - Page 32

3. SPEClFKATlONS /MELSEC-A
For a sequence of positions, the first of which are defined as
pattern "1 1 ", the "M code ON" signal is not given until the first
"00" or "01" pattern data is reached. In this case the M code
itself is given at the first position. This is illustrated below.
Pattern 00
Dwell
-
I'
1 \,
M code
I] I
I
BUSY I
I
"M code ON"
(WITH mode)
I
I
"M code ON"
(AFTER mode)
"M code OFF"
Fig. 3.10 "M code ON" Simrl Timing for Positioning haern "1 1"