Mitsubishi MELSEC-A series User Manual

(6) Emergency stop signal
Emergency stop signals must be hard wired into the system.
(7) Upper and lower stroke limit values should be checked before
operation.
(8) The speed limit parameter should be checked before operation.
(9) Set the jog speed low when initially setting up the system.
(10) For interpolation positioning, set the X and Y axis speeds to the
same value. This will represent the maximum speed that either
axis can travel at.
6-4
18 INA) 861014

Mitsubishi MELSEC-A series Specifications

General

Brand	Mitsubishi
Model	MELSEC-A series
Category	Controller
Language	English