Mitsubishi MELSEC-Q/L User Manual

366
NDIS, NDISP, NUNI, NUNIP
NUNI
(1) Links individual bits of data stored into the area starting from the device number designated by in the number of bits
specified by , and stores them following the device number designated by .
(2) The number of bits to be linked as designated by can be within a range of from 1 to 16.
(3) Processing will be performed on the number of bits to be linked from the device number designated by to the device
number storing "0".
(4) Do not overlap the device range for data to be linked ( to end range of ) with the device range which stores the linked
data ( to end range of ). If overlapped, the correct operation result may not be obtained.
(5) Do not overlap the device numbers to be designated at , , and . If overlapped, correct operation is not possible.
Operation Error
(1) In any of the following cases, an operation error occurs, the error flag (SM0) turns ON, and an error code is stored into
SD0.
Error
code
Error details
Q00J/
Q00/
Q01
QnH QnPH QnPRH QnU LCPU
4100
The number of bits dissociated or linked specified by has not been
set within the range from 1 to 16 bits.
4101
The device number of the device specified by or based on the
number of bits dissociated or linked specified by is greater than the
final device number of each device.
S1
S2
D
S1
S2
D
S2
S2
S2
S2
S2
S2
S2
S1
S1
D
b0b5
b0b7
b0b5
b0b5b6b15b14b13
b8b15 b3 b0b4b7
b12 b0b10
b0b4
b0
b7
b0b9
b0b2
6
4
8
3
0
Designation of the end of setting
Designation of the number of linked bits
8
6
10
S1
S1
S1
D
S1
+1
+1
+2
+2
+3
+3
+4
+4
+5
+5
+6
+6
+7
Number of bits
designated at
S2
Number of bits
designated at +1
S2
Number of bits
designated at +2
S2
Number of bits
designated at +3
S2
Number of bits
designated at +4
S2
Number of bits
designated at +5
S2
Number of bits
designated at +6
S2
S2
S2
S1 S1
D D
S1
S2
D
S2
S1
D
S2

Mitsubishi MELSEC-Q/L Specifications

General

Brand	Mitsubishi
Model	MELSEC-Q/L
Category	Controller
Language	English