141
OUT T, OUTH T, OUT ST, OUTH ST
1
2
3
4
5
6
7
8
5.3 Output Instructions
5.3.2 OUT T, OUTH T, OUT ST, OUTH ST
: Timer number (bit)
Set value: Value set for timer (BIN 16 bits *1)
*1: The value setting for the timer cannot be designated indirectly.
See Page 100, Section 3.4 for further information on indirect designation.
*2: Timer values can be set only as a decimal constant (K). Hexadecimal constants (H) and real numbers cannot be used for
timer settings.
Function
(1) When the operation results up to the OUT instruction are ON, the timer coil goes ON and the timer counts up to the value
that has been set; when the time up status (total numeric value is equal to or greater than the setting value), the contact
responds as follows:
5.3.2 OUT T L ow-speed timer
OUTH T High-speed time r
OUT ST Low-speed rete ntive timer
OUTH ST High-speed reten tive timer
5.3.2
OUT T, OUTH T, OUT ST, OUTH ST
Setting
Data
Internal Devices
R, ZR
J\
U\G
Zn
Constants
K
Other
Bit Word Bit Word
(Only T)
–– –– –– –– –– –– ––
Set value ––
(Other
than T, C)
–– ––
*2
––
A Contact Continuity
B Contact Non-continuity
Basic
Process
High
performance
Redundant
Universal
LCPU
T0
Set value
Setting in the range
from 1 to 32767 is valid.
K50
T0
Set value
Data register value in
the range from 1 to
32767 is valid.
D10
T0
Set value
Setting in the range
from 1 to 32767 is valid.
K50
H
T0
Set value
Data register value in
the range from 1 to
32767 is valid.
D10H
ST0
Set value
Setting in the range
from 1 to 32767 is valid.
K50
ST0
Set value
Data register value in
the range from 1 to
32767 is valid.
D10
ST0
Set value
Setting in the range
from 1 to 32767 is valid.
K50H
ST0
Set value
Data register value in
the range from 1 to
32767 is valid.
D10H
OUT T
OUTH T
OUT ST
OUTH ST
Command
Command
Command
Command
Command
Command
Command
Command
(High-speed retentive timer)
(Low-speed timer)
(High-speed timer)
(Low-speed retentive timer)
D
D
@D0
T0
Indirect designation is
not permitted.
To Next Page
Loading...
Need help?
General
