668
S.ZCOM, SP.ZCOM
Operation Error
(1) In any of the following cases, an operation error occurs, the error flag (SM0) turns ON, and an error code is stored into
SD0.
*1: This error applies to modules whose first five digits of the serial number is "13012" or later.
To perform only communication with external devices, use the COM instruction (refer to Page 407, Section 7.6.9 and Page
409, Section 7.6.10).
Program Example
(1) The following program conducts a link refresh for the network module of network No. 6 while X0 is ON.
[Ladder Mode] [List Mode]
(2) The following program conducts a link refresh for the network module mounted to the position whose head I/O number is
a X/Y30 to X/Y4F while X0 is ON.
[Ladder Mode] [List Mode]
Error
code
Error details
Q00J/
Q00/
Q01
QnH QnPH QnPRH QnU LCPU
2111
The module specified with the head I/O number is not a network
module or intelligent function module.
––
4102
The specified network number is not connected to the host station.
*1
The module specified with the head I/O number is not a network
module or intelligent function module.
–– –– –– ––
Instruction
Device
Step
Instruction
Device
Step
To Next Page
Loading...
Need help?
General
