3-86 Parallel I/O unit
3 Controller
■ Installation method
The expansion parallel input/output unit is installed outside of the controller. Connect with the network
connection cable (NETcable-1) from the RIO connector in the rear/into of the controller.(Terminator is connected
at the time of shipment)
Fig.3-36 ： Installing the parallel I/O unit (CR750)
RIOコネクタ
60
54 6
放熱、配線余裕
150
6
156
2-Ｍ ５ネ ジ
6
168
放熱余裕
128
(1 75 )
100
天
配線余裕
(4 0)
地
<2A-RZ361>
制御盤取付寸法
2A-RZ361の 取付寸法
6
Installation dimensions of 2A-RZ361/371 (The controller outside installation.)
RIO connector
Upside
Wiring space
Heat radiation
space
2-M5 screw
Downside
Radiation/wiring
space
Control panel installation dimensions
<CR750 controller>
Note) Note)
Note) The form of the machine cable connector
(CN1/CN2) may differ in RV-2F series.
To Next Page
Loading...
