(4) Measurement
Key operation Response display/output Description
1 [ ∇ ]
Press the low-speed movement key to bring the spindle
into contact with a workpiece. The spindle moves only
while the key is held down.
The moving speed with the [ ∇ ] key can be selected
from 4mm/s and 2mm/s by setting P. No.37.
2 Press [ZERO] key.
The origin is set at the origin position.
Check the “0” display at the origin position several times.
3
Press [ ∇ ] to bring
the
spindle into contact with
a workpiece.
The WORK indicator lights up.
When the spindle comes in contact with a workpiece, the
WORK indicator lights up and the measurement is
ready. Read out the measurement value when it
becomes stable.
After the WORK indicator lights up, the spindle traces
the movement of the workpiece even if the [ ∇ ] key is
released. If the workpiece moves exceeding the spindle
trace speed, the WORK indicator flashes.
4
Press [ ∆
] to separate the
spindle from a workpiece.
Press the [ ∆
] key to exit the trace mode.
IMORTANT
●Do not use high-speed movement key when the spindle comes in contact with a workpiece.
●When taking measurement, be sure to contact with the workpiece by using the [ ∇ ] key to measure and press the
[ ∇ ] key until the WORK lump I lights up. The measurement value is the value when the WORK lump lights up.
(5) Peak mode setup:Select the display value from among the maximum value, minimum value, total
indicator reading (TIR: Max. – Min.), and current value(NOM).
Key operation Response display/output Description
1
Press [MODE] key.
MAX
MIN
TIR
Each time the [MODE] key is pressed, the display value
mode is changed in the order of NOM, MAX, MIN, and
TIR cyclically.
MA
MIN
TIR
NOM
MAX
MIN
TIR
MAX
MAX
MIN
TIR
MIN
MAX
MIN
TIR
TIR
(6) Clearing the peak value
If the peak mode is set to MAX, MIN, or TIR, the peak value can be cleared according to the following
procedure.
Key operation Response display/output Description
1
Press [MODE] key. The peak indicator lights up.
Enter either of the peak modes
beforehand.
2
Press [ZERO] key.
Display after operation:
• In the MAX mode: the current value is displayed.
• In the MIN mode: the current value is displayed.
• In the TIR mode: 0.000 is displayed.
(7) Clearing an error
Key operation Response display/output
1 Error occurrence
An error cause number is displayed at the lowest two
digits.(Refer to Chapter 5 for detail.)
2 Press [ZERO] key.
The error is cleared.
No. 99MBC082B
4 - 2
To Next Page
Loading...
