EMC INDUSTRIAL GROUP LTD Keys
MW93A_IM_ALL_SV6.09f_en 59/59
Press the ALARM key to see the alarm menu and acknowledge the alarms. The menu shows a list of the
previous alarms.
For details on an alarm in the list, use the UP, DOWN and ENTER keys, or key in the number next to
the alarm.
Press BACK to exit the alarm menu, or press 6 to clear the alarms and exit the menu.
Alarms
Alarm Comments
112 weight fault
AI1 < -4mV/V: faulty loadcell or wiring
AI1 > 4mV/V: faulty loadcell or wiring
weight too low
weight too high
no sense voltage: faulty loadcell or wiring
113
114 flowrate fault flowrate too high
115 not filling or discharging material flow may be blocked
116 low flow fault flowrate setpoint cannot be achieved
117
118 error limit fault abs(error) > error limit
119
120
121 user fault 1
122 user fault 2
123 user fault 3
124
125 Comms fault
126 P-Module not compatible
127 no P-Module fitted fit P-Module
176
177
178
179
180 can't start stop input is on
181 auto setup failure flowrates measured are out of range
182 weight not stable or outside zero band
183 zero limited signal > 3mV/V
184 span limited signal too low to span
185
186
187
188
189
190
191
192
193
194
195 power supply brown out check power supply
196 error at power down totaliser and other data may be invalid
197 setting error at address ####
198 macro error
at address ####
excess recursion at address ####
bit stack error at address ####
200 controller alarm
STORAGE error: unit requires servicing
COP error: unit requires servicing
RAM error: cycle power and check alarms
controller fault: contact your supplier
language file data error
201 P-Module alarm STORAGE error: unit requires servicing
202 MO3 card alarm STORAGE error: unit requires servicing
203 MR1 alarm
To Previous Page
Loading...
