Moog DS2000 User Manual

SECTION TWO – WIRING AND INSTALLATION
DS2000 USER’S MANUAL (rev.C)
2.1
2. GENERAL INFORMATION
2.1 INTRODUCTION
This section describes the installation, wiring and cabling of the Moog DS2000 servo drive
series. Such information allows the understanding of DS2000 functionality and makes clear
the necessary concepts to access the following sections.

Moog DS2000 Specifications

General

Input Voltage	460 VAC ±10%, 3-Phase, 50/60 Hz
Output Current	2000A
Control Method	Digital Control
Cooling Method	Forced Air
Communication Interface	Ethernet
Protection Features	Overcurrent, Overvoltage, Undervoltage, Overtemperature
Regulation	±0.1% of setpoint